![]() VCDS - Windows Based VAG/VAS Emulator Running on Windows 10 圆4Ĭhassis Type: 8D - Audi A4/S4/RS4 B5 (1995 > 2002) Thanks for any help you can provide Audizine. It is tuned by Motoza(if this matters in communicating with the engine module). I am curious if any of you have run into this problem before? Any advice on what I can do to get the software to read?Ĭar is a 2001.5 S4 with mods listed in signature. I checked all fuses related to the ECU/Diagnostic system on the driver side fuse panel and found none to be blown. ![]() I disconnected the large connection at the ABS module under the hood and still was not able to connect. ![]() All other controllers seem to work fine.Ĭar has an aftermarket radio, I disconnected the wiring from the back of the radio to be sure however I do not see the K line connected to anything on the radio harness side of the connection.Ĭar has a dash light on for the ABS system as well as Air Bags. I was able to pull codes for a lean condition on bank 1 however in the process of AutoScan doing it's thing, I discovered the fact that I cannot connect to the Engine Controller(Module 1). I had a check engine light come on last night so I scanned this morning with my VagCom cable(genuine Ross-Tech but second hand, not cheapo knockoff).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |